Every listing carries the same three strain page numbers: flowering time, height and yield. They look simple. However, each one rests on assumptions the page rarely spells out. Once you know those assumptions, two listings that looked identical start to separate.
What flowering time actually counts
Flowering time counts the weeks from the switch to a twelve-hour light schedule until the plant is ready. Therefore it does not include the vegetative weeks before that. A line listed at nine weeks may still occupy your room for thirteen or fourteen weeks in total.
Autoflowering lines work differently. Their listing usually counts from the day the seed goes in, because they do not wait for a light switch. In short, the same number means two different things depending on the type.
Why the range matters more than the number
Many pages give a range rather than a single figure. Eight to nine weeks tells you the breeder saw variation. A single figure suggests the line finished consistently in their tests. Of course, your own room adds variation of its own.
How height is measured
Height usually describes a plant grown in a pot under a normal schedule, measured at harvest. Besides that, the figure assumes the grower did nothing to restrain the plant. Training, topping and a smaller pot all pull the final number down.
That is why a line listed at 120 centimetres can finish at 80 in a short tent. The listing describes a tendency, not a promise. In practice, growers read height as a relative signal: this line stretches more than that one.
The stretch after the switch
Most of the height arrives in the first two or three weeks after the light switch. Some lines double in that window; others add a third. Therefore the listed height tells you how much room to leave above the canopy. Not how tall the plant is on day one.
What yield figures describe
Yield appears in two forms. Indoor figures usually come as grams per square metre under a stated light. Outdoor figures usually come as grams per plant, because outdoor plants have no fixed footprint. The two are not comparable.
Both figures assume an experienced grower, a healthy plant and a full cycle. However, they also assume a specific light intensity and a specific plant count. Change either one and the number moves.
Why per-metre and per-plant differ so much
Four small plants can fill a square metre as completely as one large plant. The per-metre figure therefore says more about the canopy than about the individual plant. When a page gives you only a per-plant figure, look for the spacing it assumed.
Reading the three numbers together
The three numbers interact. A short line with a fast finish usually yields less per plant. But it lets you run more plants and more cycles. A tall, slow line yields more per plant and occupies the room for longer. Neither is better in the abstract.
Start from your constraint. If your ceiling is low, height decides. If you share the room with something else, flowering time decides. Yield is the number you optimise last, once the other two fit.
Where the numbers stop helping
No listing can tell you what your room does. Temperature, airflow, pot size and feeding all shift the outcome. Therefore treat the three numbers as a starting bracket and let your own notes narrow it over two or three cycles.
Comparing two listings fairly
Put the two pages side by side and check the type first: photoperiod or autoflowering. Then check whether yield is per metre or per plant. Only after that does the comparison mean anything.
If one page gives a range and the other a single figure. Treat the range as the more honest of the two. A breeder who publishes eight to ten weeks has told you something a flat nine hides.
What a light figure adds to a yield claim
A yield in grams per square metre only means something beside the light it assumed. Six hundred grams under a strong fixture is a different claim from the same figure under a modest one. Therefore look for the wattage or the light type near the number.
When a page omits it entirely, treat the figure as a rough upper bracket rather than an expectation.
Keeping your own version of the three numbers
After each cycle, write down what the line actually did in your room: weeks from the switch. Final height, dry weight. In addition, note the pot size and the light. Three cycles of that beats any catalogue.
Those notes also make the next listing easier to read. You start comparing the page against your own history instead of against a promise.
Why two catalogues list the same line differently
Two shops often describe one line with different figures. Each tested in its own room, with its own light and its own schedule. In short, the difference usually says more about the test than about the genetics.
When that happens, take the lower figure as your planning number. You can be pleasantly surprised, but you cannot un-buy a plant that outgrew the tent.
Harvest windows and the last week
The listed week marks the start of a window, not a deadline. Many growers take a line a few days either side of it depending on what they want from the finish. Therefore plan the final week loosely.
A line listed at nine weeks that you take at nine and a half has not failed its listing. It simply finished the way you chose.
Reading a listing for a small tent
In a 60 by 60 tent, height and flowering time do almost all the work. You want a line that stays short and finishes predictably. Yield follows from how well you fill that small canopy.
A tall line in that space costs you more than it gives. The listing warned you; the trick is reading it before you order.
Where the three numbers come from
A breeder arrives at these figures by running the line repeatedly under conditions they control. Therefore the numbers describe an average across those runs, not a single spectacular plant. A careful breeder throws out the outliers before publishing.
That is also why the figures change slightly between catalogue editions. More runs, a narrower average. In practice, an older listing and a newer one for the same line usually converge over time.
Photoperiod and autoflowering side by side
The two types answer different questions. A photoperiod line gives you control over when flowering starts, so you decide the final size. An autoflowering line decides for itself and finishes on its own schedule.
Therefore the same listed height means less on an autoflowering page. The plant will reach roughly that size whatever you do, because it does not wait for your light switch.
A quick method for any listing
Read the type, then the flowering time, then the height, and only then the yield. Four steps, always the same order. Once it becomes habit, a listing takes you twenty seconds.
Seeds Genetics Co. lists all four in the same place on every product page, which makes that habit easy to keep.
Want to see the three numbers on real pages? Compare Fritter Licker feminized, a longer-flowering line, with Moonbow feminized and its tighter schedule. An autoflower such as Northern Lights Autoflower produces a different calculation again.
Frequently asked questions
Does flowering time include the vegetative stage?
For photoperiod lines, no. The count starts at the light switch. Autoflowering listings usually count from seed instead, so read the type before you read the weeks.
Why is the listed height so different from mine?
Because the figure assumes an untrained plant in a standard pot. Training, a smaller pot and a shorter veg all reduce it. The listing is a tendency, not a target.
Can I compare per-metre and per-plant yields?
Not directly. One describes a canopy, the other a single plant. To compare them you need the plant count and the spacing behind the per-metre figure.
Which of the three numbers should I read first?
Whichever one your room limits. Low ceiling means height; a shared schedule means flowering time. Yield comes last, once the first two fit.
